Description

Sbb Pro2 Key Programmer V48.99 Replace CK100 Key programmer 46.02

SBB PRO2 Key Programmer has been given an update. The updated version v48.88 supports several new cars of the 2017 model like Acura 2017, Dodge 2017, Cadillac, Chevrolet 2017, Ford 2017 as well as Toyota 2017 and Buick 2017.

Highlights of SBB Pro2 Key Programmer:

SBB Pro 2 Key Programmer has been updated to 48.88
It comes with different languages support English, Turkish, Portuguese, François, Italian, Deutsch and Español.
It doesn’t have limited tokens.
It supports Toyota G Chip.
It supports the 2017 model of Honda, Ford, Toyota and many more.

The SBB Pro 2 Key Programmer is highly recommended for European cars and there is no token system

1. SBB Pro2 Key Programming innovative remote controls
2. Functions via a menu guided program
3. Reactivating keys aren’t under the car owner’s control
4. Reading keys available from pin code or memory of the immobilizer.
5. New programming keys

SBB Pro Key Programmer Car List

Multi Brands
1	Acura	HONDA	MITSUBISHI USA
2	Alfa Romeo	HONDA USA	NISSAN
3	AUDI	HYUNDAI	NISSAN JAPAN
4	CADILLAC (GM)	HYUNDAI USA	NISSAN (TRUCKS)
5	CHEVROLET – for DAEWOO	JAGUAR	NISSAN USA
6	CHRYSLER	JEEP	OPEL-for VAUXHALL
7	CITROEN	KIA	PEUGEOT
8	DODGE	KIA USA	RENAULT
9	EAGLE	LANCIA	SEAT
10	FIAT	LEXUS	SKODA
11	FIAT – PSA	LINCOLN	SUBARU
12	FORD AUSTRALIA	MAZDA	SUZUKI
13	FORD EU	MERCURY	TOYOTA – PSA
14	FORD USA	MITSUBISHI	TOYOTA USA
15	GENERAL MOTORS BRASIL	MITSUBISHI AUSTRALIA	VOLKSWAGEN
16	HOLDEN	MITSUBISHI GREEK	VOLKSWAGEN (BRAZIL)

SBB Key Programmer Pin code :

PIN Code Service
HYUNDAI pincode
KIA pincode
NISSAN bcm code
VAG pincode
VAG 7-4 pincode

Ways to use SBB PRO2 to make keys

Before you run the SBB Pro 2 key programmer, just insert the new key in the keyhole of your car.
Switch on the ignition.
Put the SBB 16-pin interface in the diagnostic seat of your car OBD2.
Go by the instructions displayed on the SBB Display

SBB PRO2 key programmer easily just copies chip as per the model of your vehicle and it programs your key rather than cloning it. You just need to insert SBB 16-pin interface in the diagnostic seat of your car’s OBD2 and allow the immobilizer dump to read the immobilizer pin code of the car before writing the program on the blank key. If you are programming for Ford cars, you don’t need pin code.

The package of SBB Pro 2 has: